![]() This means that you should typically plug and power on the nodes in the order in which you would like the numbering to go.Īfter powering up the nodes, you can do a dry-run with the script by running it, from your terminal, without any ~]# /cm/local/examples/cmd/python/newnodes.py So the first detected MAC address is assigned to the first unassigned physical node. Note the MAC address is assigned to a node in the order in which the mac address was detected. ![]() Type Hostname MAC Category Ip Network Status ![]() In other words, they are typically “placeholder identities”, until the association is actually done.įor example, when the newnodes.py script runs, the first MAC address detected with the new nodes property gets attached to the first physical node which has no MAC address as a property. These identities are typically objects that have been created earlier. The script takes the MAC addresses that are detected and associates them with physical node identities. Make sure your Bright Cluster Manager is updated to the latest version before using the script. cm/local/examples/cmd/python/newnodes.py ![]() It can be done using a script that comes in the pythoncm examples at: The following technique can save labor, when you are adding a large number of new nodes to the cluster in order to embiggen it. This article is being updated. Please be aware the content herein, not limited to version numbers and slight syntax changes, may not match the output from the most recent versions of Bright. This notation will be removed when the content has been updated. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |